Ampetronic

ILR3+

Hearing Loop Tester and Receiver

Product code: TILR03

Description

ILR3+ hearing loop tester / receiver

Using the ILR3+ to Check a Loop System

The ILR3+ is designed to make it simple for anyone to regularly check that a loop system is working, has a field strength of the correct level to provide benefit, and meets the IEC60118-4 standard.

Field Strength Indicators

As dictated by the international standard, the ILR3+ has two indicators and these are calibrated to illuminate when the field strength is 400mA/m (0dB) or higher (GREEN) and between 200 and 400mA/m (-6 and 0dB) (YELLOW)

Checking Loop System Status

The status of the loop can be easily checked by running continuous speech or music into the loop and monitoring the indicators when the ILR3+ is held in the appropriate location. A simple table on the back of the ILR3+ shows what is acceptable or not.

User Instructions

The ILR3+ hearing loop tester / receiver comes with a simple user procedure to help guide anyone through the checking process. Using the ILR3+ requires no special knowledge of loop systems or any technical knowledge.

Who can use the ILR3+?

The ILR3+ is ideal for regular use by a facilities manager or non-technical member of staff. Regular use will ensure that the provider of the service keeps the loop system working and providing a genuine benefit to the hard of hearing. The ILR3+ is an essential companion to any loop system installation.

Technical specifications

Low Cut Filter

The ILR3 incorporates a low cut filter. Switching the low cut filter on attenuates the low frequency (bass) components of the signal emulating a typical hearing aid response and helps reduce the annoying ‘buzz’ caused by some AC power circuits.

For best reception in general use and where there is no low frequency interference, the ILR3 should be used with the ‘flat’ frequency
response selected.

Specification

Frequency response Standard: Flat 85Hz – 6kHz ± 0.5dB
Low Cut: 400Hz – 6kHz – 3dB (similar to hearing aid)
Output power >100mW into 16Ω load
Distortion
Battery powered 2 x Alkaline AA (included)
Battery life >100 hours with Alkaline batteries
Indication ‘Good’ 0dB Green LED 400mA/m rms with sine
‘Okay’ -6dB Amber LED 400mA/m rms with sine

Physical

Dimensions width 62mm, depth 26mm, height 112mm
Temperature range IP20 : 20 to 90% relative humidity, -10 to 45ºC

Accessories

Stereo headphones impedance 32Ω per side (included)

More in this family