Ampetronic

ILR3

İndüksiyon Döngü Alıcısı

Ürün kodu: TILR03

Açıklama

ILR3 Audio loop receiver

The ILR3+ also has LED indications to show field strength, for more accurate monitoring of a loop system. (To measure the performance of an induction loop system, Ampetronic's calibrated receiver CMR3 must be used). In addition, the ILR3 or ILR3+ can be used by anyone without a hearing aid who needs a little extra assistance to hear.

Applications include

  • Checking that an induction loop system is working. Essential for installers, venue managers and event organisers
  • Recording the output of a loop system
  • Providing assistance to people without a hearing aid
  • Locating sources of interference
  • Checking loop coverage and signal overspill

Features

  • Low distortion
  • Flat frequency response to 6kHz
  • Low cut filter—to simulate hearing aid response
  • Low and high field strength indicators according to IEC60118-4 (ILR3+)
  • Volume control
  • 5 year warranty
  • Auto power off with headphone removal
  • > 100 hours life with 2 AA batteries

Teknik özellikler

Low Cut Filter

The ILR3 incorporates a low cut filter. Switching the low cut filter on attenuates the low frequency (bass) components of the signal emulating a typical hearing aid response and helps reduce the annoying ‘buzz’ caused by some AC power circuits.

For best reception in general use and where there is no low frequency interference, the ILR3 should be used with the ‘flat’ frequency
response selected.

Specification

Frekans yanıtı Standard: Flat 85Hz – 6kHz ± 0.5dB
Low Cut: 400Hz – 6kHz – 3dB (similar to hearing aid)
Output power >100mW into 16Ω load
Distortion
Battery powered 2 x Alkaline AA (included)
Battery life >100 hours with Alkaline batteries

Physical

Boyutlar width 62mm, depth 26mm, height 112mm
Temperature range IP20 : 20 to 90% relative humidity, -10 to 45ºC

Accessories

Stereo headphones impedance 32Ω per side (included)

Aynı ailedeki ürünler